Adjustment, Step 1 program the travel limits, Adjustment step 1 – Chamberlain Security+ 3900PLD User Manual

Page 17: Program the travel limits

Advertising
background image

17

To prevent damage to vehicles, be sure fully open door
provides adequate clearance.

BLACK

PURPLE

Push and hold
until the door
is at desired UP
position

Figure 2

Figure 3

Push either
button to stop
door at desired
DOWN position

BLACK

PURPLE

Figure 4

Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing door.
• NEVER learn forces or limits when door is binding or

sticking. Repair door first.

• Incorrect adjustment of door travel limits will interfere with

proper operation of safety reversal system.

• After ANY adjustments are made, the safety reversal system

MUST be tested. Door MUST reverse on contact with 1-1/2"
high (3.8 cm) object (or 2x4 laid flat) on floor.

ADJUSTMENT STEP 1

Program the Travel Limits

Travel limits regulate the points at which the door will
stop when moving up or down.

Adjust the position of the door by using the black and
purple buttons. Black moves the door UP (open) and
purple moves the door DOWN (close).

Setting the UP position:

1. Press and hold the black button until the LED starts

flashing slowly, then release (Figure 2).

2. Push and hold the black button until the door reaches

the desired UP (open) position.

NOTE: Make sure the door opens high enough for your
vehicle.
3. Push the door control or programmed remote control.

This sets the UP (open) limit and begins closing the
door (Figure 3).

4. Immediately when the door begins to close, press and

release either the black or purple button. This will stop
the door.

Setting the DOWN position:

5. Push and hold the purple button until the door reaches

the desired DOWN (closed) position.

6. Once the door is closed, if there appears to be too

much pressure on the door, you may toggle the door
back and forth using the black and purple buttons to
reach the desired closed position.

7. Push the door control or programmed remote control.

This sets the DOWN (close) limit and the door should
open.

Proceed to Set the Force.

Purple
Button

LED

Black
Button

Figure 1

Advertising