Cisco XR 12000 Series - Manual (Page 97)

2-67
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
Cisco XR12000 IPSec VPN SPA Overview
2-Port OC48-POS/RPR SPA Interface Specifications
The physical layer interface for the 2-Port OC48-POS/RPR SPA is Optical Carrier-48 (OC-48), and the
2-Port OC48-POS/RPR SPA is designed to comply with POS specifications. The
2-Port OC48-POS/RPR SPA provides two 2.488-Gbps network interfaces for all supported platforms.
2-Port OC48-POS/RPR SPA Cables, Optical Transceiver Modules, and
Connectors
Use single-mode (for intermediate-configurations) optical fiber cable to connect your router to a network
or to connect two OC-48-equipped routers back-to-back.
The 2-Port OC48-POS/RPR SPA supports the following types of optical transceiver modules:
• Single-mode short-reach (SR) SFP module—SFP-OC48-SR
• Single-mode intermediate-reach (IR) SFP module —SFP-OC48-IR1
• Single-mode long-reach (LR) SFP module — SFP-OC48-LR2
Each port on the 2-Port OC48-POS/RPR SPA has one duplex LC-type receptacle. For single-mode
optical fiber connections, you can use either a duplex LC-type cable (see
Figure 2-48 ) or two simplex
LC-type cables, one for transmit (TX) and one for receive (RX).
Figure 2-48 Duplex Patch Cable with LC-Type Connectors
Cisco XR12000 IPSec VPN SPA Overview
The Cisco XR12000 IPSec VPN SPA (SPA) provides remote access and remote site VPN connectivity
for the Cisco XR 12000 Series Router.
The following features are supported:
• Site-to-Site communication over point-to-point IPSec/GRE tunnels
• Remote User Access over IPSec tunnels.
Any slot of the Cisco XR 12000 Series Router that contains a Cisco XR 12000 SIP-401, Cisco XR 12000
SIP-501, or a Cisco XR 12000 SIP-601 can support up to two Cisco XR12000 IPSec VPN SPAs, or any
mixture of the Cisco XR12000 IPSec VPN SPA with other interface SPA types on the same SIP card.
/ / / /
/ /
TX RX
84929