Great Planes Big Stik 60 ARF MonoKote - GPMA1221 - Manual (Page 12)

❏
5. Install the engine with four washers and four socket
head screws of the size listed in the table.
❏
1. Locate the four blind nuts in the bottom of the fuse. Cut
the covering from the inside of the holes.
❏
2. Mount the aluminum landing gear to the fuse with the
four washers and four socket head screws of the size listed
for your model.
❏
3. Locate the wire nose gear, plastic steering arm, two
5/32" [4mm] wheel collars and two 6-32 x 1/4" [6mm] socket
head screws. Place one wheel collar into the center of the
steering arm and hold it in place with one screw. Insert the
second screw into the remaining wheel collar. Place the
steering arm onto the wire nose wheel wire and insert the
nose gear into the landing gear mount holes of the engine
mount. The steering arm should line up with the hole in the
firewall for the steering pushrod. Place the other wheel collar
on the top of the wire, above the top of the engine mount.
Tighten the screws. This will hold the wire in place. Note: It
might be necessary to enlarge the hole in the engine mount
slightly to fit the nose gear.
❏
4. Locate two 5/32" [4mm] wheel collars and two 6-32 x
1/4" [6mm] socket head screws. Put the screws in the wheel
collars. Slide one collar onto the nose wheel axle, then the
nose wheel and then the remaining collar. File a flat spot on
the nose gear wire where the outside wheel collar will be.
Tighten the screws to hold the wheel on the center of the axle.
MOUNT THE LANDING GEAR
12
.40 Size .60 Size
Gear mounting washers #6 #8
Gear mounting bolts 6-32 x 3/4 " 8-32 x 1 "
Specific Measurements
and Hardware Usages