Great Planes Big Stik 60 ARF MonoKote - GPMA1221 - Manual (Page 6)

❏
1. From the 2" x 9" [50mm x 230mm] hinge material, cut
out 16 hinges, 3/4" x 1" each [19mm x 25mm].
❏ ❏
2. Insert a T-pin through the center of 4 hinges. Trial
fit the 4 hinges into the right wing panel, making sure the
T-pin is flush against the wing.
❏ ❏
3. Test fit the right aileron to the right wing. The aileron
should be tight against the T-pins, with no more than a 1/32"
gap at any point. When satisfied with the fit, remove the
T-pins and attach the aileron by applying 6 drops of thin CA
to each side of each hinge. After the glue has cured, flex the
aileron back and forth a few times to loosen up the hinges.
Pull on the aileron to make sure that the aileron is firmly
attached to the wing.
❏ ❏
4. Using the photo as a guideline, locate the servo bay
in the bottom of the right wing panel. Cut the MonoKote
1/16" to the inside of the edges of the servo tray. Using a
MonoKote Covering Iron or Trim Tool, iron the edges down
into the servo tray. NOTE: It is important that you securely
iron down the edges to avoid the possibility of the covering
“flapping” and peeling off.
❏ ❏
5. Using a dime for size reference and a hobby knife,
cut a hole in the BOTTOM of the wing parallel to the hole in
the root rib and 1/2" from the root rib.
1"
1"
3/4"
WING ASSEMBLY & INSTALLATION
6