Great Planes PT-60 Kit - GPMA0119 - Manual (Page 38)

Make a mark 3/16" from the first mark.
D 14. Insert the Z-bends into the servo horn and reattach
the swivel clevises. Mount the horn on the servo and test
the aileron's operation.
Make a 90 bend at the outside mark.
Make a 90 degree bend at the inside mark.
D 15. Screw a 6" threaded pushrod 14 revolutions into a
nylon swivel clevis. Screw a nylon swivel onto one of the
aileron torque rods so that 1/4" of thread protrudes above
the top of the swivel. Snap the swivel clevis onto the swivel.
Repeat this operation for the other torque rod.
5-5/8"
D 16. Mark both wire pushrods exactly 5-5/8" from the
back end of both clevises. Use the instructions at step 13 to
make Z-bends at the mark on both pushrods or use a Z-
bend pliers.
D 17. Drill two 5/64" holes through the punch marks on the
die-cut 1/8" ply aileron lock. Insert the Z-bends into these
holes, then position the aileron lock on the servo tray.
Twist the pushrod straight.
Cut any extra wire off the ends and sand or file the burrs off
of the ends to prevent scratching yourself later.
D 18. Temporarily lock both ailerons in position with
popsicle sticks and clothespins as shown. Drill a 1/16" hole
through both ends of the aileron lock into the side rails of
the servo tray. Enlarge the holes in only the aileron lock
with a 3/32" drill bit.
38