Great Planes Cosmic Wind Minnow 60 ARF - GPMA1321 - Manual (Page 13)

❏ ❏
4. Insert a 6-32 set screw into a 5/32" [4mm] wheel
collar. Slide it onto the axle. Slide the wheel onto the axle and
then slide another 5/32" wheel collar. Screw a 6-32 x1/4"
[6mm] socket head cap screw into the wheel collar with a
drop of threadlocker. Center the wheel, then tighten the set
screws on the wheel collars.
❏ ❏
5. Slide the wheel pant over the wheel. Attach the
wheel pant to the landing gear with two 4-40 x 1/2" [13mm]
machine screws, a drop of threadlocker, #4 flat washers and
#4 lock washers.
❏
6. Repeat steps 3-5 for the other wheel pant.
❏
7. Install the tail wheel onto the tail wheel wire. Lock it in
place with a 3/32" [2.4mm] wheel collar and a 4-40 set screw
with a drop of threadlocker.
❏
1. Mount the wing to the fuselage with the 1/4-20 nylon bolts.
❏
2. Place the canopy base on top of the wing aligning it to
the fuselage. Trace the outline of the canopy base to the wing.
❏
3. Carefully cut away the covering inside the lines you
have drawn.
Mount the Canopy to the Wing
13