Great Planes Cosmic Wind Minnow 60 ARF - GPMA1321 - Manual (Page 19)

wire pushrod with the hole in the end of the servo arm. Use
a fine-point felt-tip pen to mark the wire where it crosses the
holes in the servo arm. On that mark make a 90 degree
bend. From the bend measure an additional 3/16" [4.8mm]
then cut off the excess pushrod wire. Install a nylon Faslink
to the wire and servo arm.
❏
7. Install the elevator servo into the servo tray. Position it
in line with the elevator pushrods. Mount the servo using the
same procedure used for the rudder servo.
❏
8. Make a bend in one of the elevator pushrod wires as
shown. Cut the excess wire 3/8" [10mm] from the bend.
❏
9. Screw a 6-32 x 1/4" [6mm] socket head cap screw with
a small amount of threadlocker into two 5/32" [4mm] wheel
collars. Slide the wheel collars onto the wires. Align the
elevators. Tighten the set screws against the wires.
❏
10. Be sure the elevator servo is centered. Enlarge the
first hole in the servo arm with a Hobbico Servo Horn Drill
(or a #48 or 5/64" [2mm] drill bit). Center the elevators and
align the wire pushrod with the hole in the end of the servo
arm. Using a marker, mark the location where the wire aligns
with the hole in the servo arm. On that mark make a 90
degree bend. From the bend measure an additional 3/16"
[4.8mm] then cut off the excess pushrod wire. Install a nylon
Faslink to the wire and servo arm.
❏
11. Install a switch harness and charge jack in the
fuselage. Connect the switch to the battery. Be sure to use
heat shrink or tape to be sure the battery to switch
connection is secure.
❏
12. Install the battery and receiver as shown. Place 1/4"
[6mm] thick foam under the receiver and battery, holding it
in place with the Velcro material (included with the kit). Insert
the receiver antenna into the antenna tube.
19