Great Planes Cosmic Wind Minnow 60 ARF - GPMA1321 - Manual (Page 20)

❏
1. We installed a 1/4-scale Williams Brothers “Sportsman”
pilot (WBRQ2626). Because the Minnow was such a small
racer, the head of the pilot is all that is required. To fit the
head you will have to sand a small portion of the chin from
the pilot figure.
❏
2. Trim the canopy on the molded cut lines. Glue the
canopy in place using R/C-56 canopy glue.
1. Use scissors or a sharp hobby knife to cut the decals from
the sheet.
2. Be certain the model is clean and free from oily
fingerprints and dust. Prepare a dishpan or small bucket with
a mixture of liquid dish soap and warm water—about one
teaspoon of soap per gallon of water. Submerse the decal in
the soap and water and peel off the paper backing. Note:
Even though the decals have a “sticky-back” and are not the
water transfer type, submersing them in soap & water allows
accurate positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
❏
1. Turn on the transmitter and receiver and center the
trims. If necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall the
screws that hold on the servo arms.
Check the Control Directions
GET THE MODEL READY TO FLY
Apply the Decals
Install the Canopy
FINAL TOUCHES
20