Great Planes Fundango Park Flyer Kit - GPMA0050 - Manual (Page 10)

❏ ❏
1. Make the frame of the aileron as shown on the plan
from a 3/16" x 3/16" x 36" [4.8 x 4.8 x 910mm] balsa stick.
❏ ❏
2. Cut the cross supports from a 1/8" x 3/16" x 36"
[3.2 x 4.8 x 910mm] balsa stick. Glue the cross supports in
place using the plan as a guide.
❏ ❏
3. From a leftover piece of 3/16" x 3/16" [4.8 x 4.8mm]
balsa stick, cut the control horn support brace to the
shape shown on the plan.
❏ ❏
4. Glue the control horn support brace to the aileron
as shown on the plan. Do not glue the control horn in place.
The control horn will be glued in after the aileron is covered.
❏
5. Repeat steps 1 – 4 for the left aileron.
❏
1. Cover the fin area of the plan with Great Planes
Plan Protector.
❏
2. Make the bottom of the fin and the center fin post
from the 3/16" x 3/16" x 36" [4.8 x 4.8 x 910mm] balsa stick.
Pin the parts to your building board as you proceed.
❏
3. Fit and glue the rest of the cross-brace structure from
one of the 1/8" x 3/16" x 36" [3.2 x 4.8 x 910mm] balsa
sticks. Place a few pins around the structure to support it.
This will be helpful as you move through the steps of
wrapping the laminated frame of the fin.
Build the Fin
BUILD THE TAIL SURFACES
BUILD THE AILERONS
10