Great Planes Fundango Park Flyer Kit - GPMA0050 - Manual (Page 9)

❏
21. Locate both die-cut 1/16” [1.6mm] plywood tube
supports. Glue the narrower support to the back of the
leading edge in the center of the wing.
❏
22. Glue the remaining tube support to the back of the
main web. Be sure the hole in the main web and the rear
tube support align.
❏
23. Push a T-pin through the exact center of the tube
support on the back of the LE, all the way through the
leading edge. This will be your
pilot hole guide for drilling a
hole through the leading edge.
❏
24. Drill a 1/8" [3.2mm] pilot hole through the pin hole
guide. Once you are satisfied that the pilot hole is through
the center of the forward tube support, drill a 5/16" [7.9mm]
hole through the leading edge.
❏
25. Lightly and carefully sand the entire wing. The wing
is light and too much force could damage it.
❏
26. Test fit the fiberglass fuselage tube into the wing.
Make any adjustments to the mounting holes needed for the
tube to slide through the wing. Cut a 5/16" [7.9mm] opening
in the trailing edge of the wing to allow the tube to pass
through it. This opening must be exactly centered between
the W-1 ribs.
9