Great Planes Fundango Park Flyer Kit - GPMA0050 - Manual (Page 17)

❏
1. Drill two #60 (.040") [1mm] holes through the punch
marks in the die-cut 1/16" control horns.
❏
2. Glue the control horns into position in each of the
ailerons and the elevator, making sure they are vertical to
the control surface.
❏
1. Slide the stab and elevator onto the fuselage tube.
Make sure you have a good fit between the tube and the slot
in the stab. Sand or shim the stab as needed to get a good
fit. Be sure that the elevator moves up and down freely
without any binding when the stab is mounted.
❏
2. Make sure that the stab is parallel with the wing as
shown in the photo above. Glue the stab to the fuselage tube
with medium CA.
❏
3. Slide the fin into the slot in the rear of the fuselage
tube. Be sure that the fin is 90 degrees to the stab and
parallel with the fuse, then glue the fin into the slot.
❏
1. Drill a 5/64" [2mm] hole for the battery hook through
one side of the fuselage tube between the leading edge of
the wing and the landing gear.
(If you don't have a 5/64"
[2mm] drill bit you could use a 1/16" [1.6mm] drill bit, but
you'll have to enlarge the hole with a hobby knife.)
❏
2. Make the battery hook from .074 x 2" [1.9 x 50mm] wire.
Mount the Battery
90˚ 90˚
Mount the Stab and Fin
Mount the Control Horns
FINAL ASSEMBLY
17