Great Planes Fundango Park Flyer Kit - GPMA0050 - Manual (Page 8)

❏
13. Use a hobby knife with a #11 blade to remove the
flashing from the shaped 36" balsa leading edge. NOTE:
The leading edge is symmetrical – there is no
top or bottom.
❏
14. Cut the leading edge to a length of 35" [889mm].
❏
15. Beginning on the right side of the wing, glue the
leading edge to rib W4 with medium CA. Position the leading
edge so it is centered on the rib. When the glue has set, glue
the leading edge to W4 on the left side of the wing. Continue
to glue the leading edge to each of the W2 and W3 ribs for
the entire length of the wing, making sure that each rib is
centered on the leading edge.
❏
16. Position and glue the top spar in place in the notches
on the top of the wing above the main web.
❏
17. Cut one of the 3/16" x 3/16" x 36" [4.8 x 4.8 x 910mm]
balsa sticks to a length of 35" [889mm] to make the wing
trailing edge. Glue the trailing edge to ribs W1, W3 and W4.
❏
18. Cut both 1/16" x 1/2" x 24" [1.6 x 13 x 610mm] balsa
TE supports to fit between W1 and W3 and between W3
and W4. Do this for the left and right side of the wing, gluing
them into place. Be certain the supports are centered
vertically on the TE.
❏
19. Fit the remaining 1/16" x 1/2" x 24" [1.6 x 13 x
610mm] balsa stick between the trailing edge and the
leading edge at rib W4. When you are satisfied with the fit
glue them into place. Do this for both the left and right end
of the wing.
❏
20. Glue the 1/8" x 1/4" x 2" [3.2 x 6.4 x 51mm] balsa
servo support into the two remaining notches on ribs W1.
8