Haltech E8 - Manual (Page 25)

Haltech E11/E8 Instruction Manual
Engine Config Group
• Engine Type – Select your Engine type, Piston (reciprocating) engine or Rotary engine.
• No of Cylinders - Set this field to the number of cylinders your engine contains if you are
configuring for a piston engine
• No of Rotors – Set this field to the number of Rotors when configured for a Rotary engine Type.
• Load Sensing - Set this to match the load sensing method you are using. Most engines will
operate using manifold pressure to sense engine load. If your engine employs any form of
supercharging or Turbo charging, select a suitable MAP sensor range. Engines with wild cams,
most motorbikes, multi-throttle bodies or heavily ported rotaries will require a TPS as the load
sensing. If you are unsure what to use, contact your Haltech dealer.
Correction Maps Group
Click on the checkboxes on the left to place a tick next to the correction maps that you wish to have
enabled. To disable a map, click on the checkbox to clear the tick. Choices are Inj Coolant Map, Inj Air
Temp Correction Enable, Post Start Enrich Enable, Primer Map Enable, Post Start Type, Battery
Correction Map Enable, Barometric Correction Enable, Ignition Coolant Map Enable. Ignition Air Map
Enable and Post Start Timing Offset.
RPM Group
• Max Cranking RPM - When the engine RPM is below this value, the engine is considered to be
cranking under the starter motor power. When the RPM exceeds this value, the engine is
considered to be started and running. This allows the ECU to determine what is Cranking and what
is Running.
• Rev Limit Enable - Click on this checkbox if you want to enable the Rev Limiter.
Rev Limiter Options Group
Figure 24 - Rev Limiter Settings
Copyright © Haltech 2008 Page: 25