Haltech F9A - Manual (Page 29)

28
The F9 Programme is now ready to run.
2.2.3 Running the Software from the Hard Disk.
Boot your computer up as described earlier. If your computer is already on, make sure the C
drive is currently selected. To change to the HALTECH directory type :
F'?KDOWHFKy
or, if you used a different destination directory, type that path.
To start the programme type :
I y
The F9 programme will now run. The next section is on running the software from a floppy
drive. You can skip this section and go straight to the section entitled Azerty Keyboards.
2.2.4 Running the Software from the Floppy Disk.
To run the software from a floppy drive, boot your computer up as described earlier. Insert
the Programming disk in the disk drive. If the drive is the A drive, then it must be currently
selected. To select the A drive (or B drive if it is the required drive) type :
D y
or
% y
You should now see the prompt :
A:\>_ or B:\>_
To start the E6A program type :
HDy
The E6A program will now run.
2.2.5 Azerty Keyboards
Most countries use a keyboard where the first six letter keys across the top row are :
TZHUW\
This is called a Qwerty keyboard. Some countries use an alternative, which is called and
Azerty keyboard, where the Q and W keys are swapped with the A and Z keys respectively. If
you have an Azerty keyboard, you need to run the software slightly differently. When you
would normally type :