Haltech F9A - Manual (Page 60)

59
Chapter 10
Printing Maps
10.1 The Print Function
You can print the maps and identification information to printers that accept IBM emulation
mode, such as IBM compatible dot matrix printers (consult your printer manual). The Print
function should work with other dot matrix printers, but some special characters such as °, ±,
etc. may not print correctly. Select the print function by pressing
S
from the Options sub-
menu
The system will present you with options on which data you wish to print. There are four
options. Their meaning is as follows:
1)
Setup Information: This will print only the setup pages (ie. Fuel, Main and
Ignition pages).
2) Maps:
Prints all the maps in the system (ie. Fuel, and Coolant).
3)
Output Options: This function will print the current settings and the
status of the output options of the ECU. (ie. Turbo Wastegate).
4)
Print All Information: This will print all of the above information
The system will ask for a name to print at the top of the printed output. This allows you to
differentiate between printouts if you have printed more than one set of maps. The name can
be up to ten characters in length. Type in the name and press Enter (
y
).
The system pauses to allow you to set up the printer. If you do not want to print you can leave
the print function by pressing
}
. Pressing any other key starts the printing. Before you start
printing the printer must be Online and must have power and paper. Once the printing has
started you can abort the printing by pressing
}
.