Heli-Max HMXE7459 - Manual (Page 3)

3
❏
11. Slide one thin nylon washer onto the 2mm main blade screw.
Slide the screw with washer through the blade grip and place one
thin nylon washer onto the opposite side. Carefully slide the blade
and washers into the blade grip. Apply threadlocking compound to
the blade bolt and install it using the 2mm nut removed from the
blade grip earlier. Repeat for the opposite blade grip.
❏
12. Remove a paddle from the fl ybar. Install one brass paddle
weight onto the fl ybar and re-install the fl ybar paddle. Repeat on
the opposite side. Slide the paddle weights against the paddles
and tighten the set screws against the fl ybar. Measure and verify
both paddles are the same distance out from the fl ybar control arm.
Both paddles must be parallel with the swashplate. If you feel the
paddles rotate too easily, add a drop of CA to the threads before
threading the paddles on.
SETUP
WARNING! Unplug the main motor and tail motor before
proceeding to the following steps.
❏
1. Once you are certain the main motor and tail motor are
disconnected, turn the transmitter on, center all trims, place the
throttle at the 50% position and fl ip the Idle Up switch to the “ON”
position. Plug the fl ight battery into the E-Board and allow the gyro 10
seconds to initialize. Hold the fl ybar level and the blades should be