Heli-Max HMXM1015 - Manual (Page 8)

8
4
Attach the 3 wire male connector (rudder) from
the gyro to channel 4 of your receiver (Futaba®).
Also, plug the one wire plug from the gyro (gain)
into channel 5 (Futaba), making sure the yellow
wire is aligned with the white wire (signal) of the
other servo plugs.
5
Neatly secure the wires to eliminate any chance
of damage.
Gyro Setup
1
Turn on your transmitter.
2
Enter your radio’s menu and check to make sure REVO MIX
(Revolution Mixing) is disabled.
3
Plug the main power battery into the controller. Again, it is
best to unplug the motor or move the motor pinion gear
away from the main gear or you might risk injury.
4
Wait at least 5 seconds before moving the helicopter. This
is important as the gyro is reading its current position and
should not be disrupted at this time.
5
Moving the rudder stick left and right, adjust the LIMIT dial
so the tail pitch slider does not bottom out on the tail case or
tail hub. Start at 50 percent and work the dial either a lesser
percentage or larger percentage to complete the adjustment.