Heli-Max HMXE0821 - Manual (Page 5)

5
®
OPERATIONAL WARNINGS OPERATIONAL WARNINGS
● Please allow a 10 minute cool down period after each flight so the motor
controller and motor can cool down. Failure to do so may cause loss of control
due to the controller overheating and shutting down.
● Please inspect the main rotor blades and blade screws before each flight for
nicks or loose components. If any damage is found or if the blades have been
crashed, please replace the blades before flying the model again.
● The ESC does have a soft cut function that will reduce the power output to
protect the flight battery. Toward the end of a flight, if you notice a slight power
reduction, land the model immediately and recharge the battery. The flight
time of the AXE 100 CP can be as long as 6 minutes but this will vary depending
on your flying style.
CAUTION! After a crash you must inspect all plastic parts on the
helicopter for damage before flying the model again.
®
TRANSMITTER TRANSMITTER
Please read the transmitter manual included with your helicopter to learn more
about how to use and adjust your TX610.
TRANSMITTER FUNCTIONS AND SWITCHES
The Throttle Hold Switch
(HOLD/FLAP) is used to
disable the power output
of the motor but has no
effect on the other controls.
The Throttle Hold Function
was originally intended for
autorotation landings (off
power descent to landing);
this maneuver is really
not possible with a motor
driven tail.
In addition to autorotation
the throttle hold function can
be used as a safety switch while handling the model since it disables power to
the motor. Turn the transmitter on and set the Throttle Hold Switch to the on