Heli-Max HMXE0821 - Manual (Page 9)

9
Plug the helicopter’s power battery into
the open connector of the charger. The
charger will beep twice letting you know
the battery is connected. At this point
you can select a slower or faster charge
rate by pressing the + or – buttons
located on the face of the charger. While
the LED is illuminated you will need to
press the charge button. You will hear
3 beeps and the charge cycle will begin.
When charging is complete, all the
LEDs will flash and you will hear a
steady set of beeps coming from the
unit.
Unplug the battery. It is now ready
to use.
NOTE: Your AXE 100 CP battery
charger ranges from .3AMPS to .7AMPS
in .1 amp increments. The higher this
value, the faster the battery will charge.
We recommend not charging the battery
over 2.2C or .5AMPS (Default).
TURN THE TRANSMITTER ON
Verify that the HOLD/FLAP and UP-1/GEAR functions are off and slide the power
switch up to turn the transmitter on. If the transmitter is turned on with the HOLD/
FLAP or UP-1/GEAR function switched on, the screen will show “3D” or “T-H” and
a warning will sound. Please turn the HOLD/FLAP and UP-1/GEAR functions off
to continue. Now is a good time to make sure the electronic trim buttons on the
transmitter are centered. We do not need to use them as the precision Heli-Max
TAGS system controls all flight center trims.