Heli-Max HMXE09 User Manual

Page 5

Advertising
background image

5

ASSEMBLY INSTRUCTIONS

INSTALL BATTERIES IN THE TRANSMITTER

Remove the battery cover from the back of the transmitter,

remove the battery box and install eight (8) “AA” batteries into
the battery box. Double-check the polarity of each battery
before placing the battery box back into the transmitter and
replacing the battery cover.

Insert the transmitter antenna into the top of the transmitter

and turn it clockwise until it is tight.

Turn on the transmitter using the power switch as shown

above and verify that the LED indicator glows solid red. Turn

the transmitter off for now. If the LED indicator did not light
then remove the battery box and verify that the polarity of the
batteries are correct.

GET THE MODEL READY TO FLY

CHARGING THE FLIGHT BATTERY

WARNING!! ALWAYS ensure that the charge

indicator light is green before connecting the fl ight
battery to the charger.

ALWAYS unplug the battery from the charger when the
charge process is complete. If the battery is left connected,
the charger will discharge the battery, possibly damaging the
battery or charger.

Ensure that the fl ight battery is not connected to the

charger and plug the charger into an AC outlet. The indicator
light on the charger should illuminate solid green, indicating
that the charger is ready. If the indicator light is any color
other than green, then please ensure that the charger is
connected to an active AC outlet.

Plug the battery into the charger and the indicator light will

turn red. Once the charge process is complete the indicator
light will turn green again. The charging process may take up
to four (4) hours.

The fl ight pack used to power the AXE CX Micro contains
protective circuitry. If you experience any diffi culties while
charging or using the battery, please allow the battery to rest
for two hours as this will allow the protection circuit to reset.
This reset process is expected after a crash has occurred.
If this issue re-occurs during normal use, please contact
technical support for further assistance.

Advertising