Heli-Max HMXE0205 - Manual (Page 4)

4
❏
3. Glue the tailboom support ends onto the carbon fiber
tailboom supports with thin CA.
❏
4. Secure the tailboom supports to the rear frame using
two 2x10 mm machine screws and a rear frame spacer. Use
a drop of thread locking compound on both screws, but be
careful not to get any on the plastic parts.
❏
5. Secure the tailboom supports to the horizontal stabilizer
bracket with two 2x8 mm machine screws. Use a drop of
thread locking compound on both screws, but be careful not
to get any on the plastic parts.
❏
6. Finalize the position of the horizontal stabilizer bracket
and tighten the horizontal stabilizer screws to hold the
assembly firmly in place. Do not over-tighten.
❏
1. With the Z-bend towards the front, slide the rudder
pushrod back through both supports on the tail boom.
❏
2. Screw a ball link onto the threaded end of the
rudder pushrod.
❏
3. Connect the ball link to the ball on the tail rotor pitch
control horn. Check to see that the ball link runs freely on the
ball, and loosen it if necessary using the following Heli-Max Tip.
INSTALL THE PUSHRODS & SERVOS