Heli-Max HMXE0205 - Manual (Page 5)

❏
4. Install the rudder servo as shown, using the hardware
that came with your servo and two plastic servo nuts. The
servo mounting lugs should be on the outside of the frame.
❏
5. Center the rudder servo and install the servo arm. With
the servo centered, the tailrotor should be at approximately
zero pitch. If it is not, adjust the length of the rudder pushrod.
❏
6. Install ball links onto the ends of the elevator, aileron,
and collective pushrods.
❏
7. Install the aileron servo using the hardware that came
with your servo. If using the recommended Futaba servo,
you will need to install the metal eyelets upside-down and
install the servo under the tray, with the screws running up
into the tray.
HELI-MAX TIP
How to adjust the fit of ball links.
If a ball link does not twist freely on its ball, squeeze it
firmly with a pair of needlenose pliers
while it is
installed on the ball.
5