Heli-Max HMXE0210 - Manual (Page 5)

Use this swash plate diagram in your radio for proper setup.
❏
1. Locate the 4 aluminum balls and the 4 2mm x 6mm
machine screws. Install the 4 ball links onto all 4 control
horns (AIL, ELE, PIT, RUD).
❏
2. Using two plastic servo screw nuts, install the Aileron
servo as shown. With the aileron servo centered, the servo
arm should be completely horizontal with the ball end to the
rear as shown.
❏
3. Using two plastic servo screw nuts, install the pitch
servo as shown. With the pitch servo centered, the servo
arm should be completely horizontal with the ball end to the
rear as shown.
❏
4. Using two plastic servo screw nuts, install the elevator
servo as shown. With the elevator servo centered, the servo
arm should be completely horizontal with the ball end to the
rear. The output shaft of the servo should point towards the
front of the heli.
❏
5. Using two plastic servo screw nuts, install the rudder
servo as shown. With the rudder servo centered, the servo
arm should be completely horizontal with the ball end up as
shown. The output shaft of the servo should point towards
the rear of the heli.
INSTALL THE SERVOS
5