Training a button – HONDA 2015 Odyssey - Owner's Manual User Manual

Page 327

Advertising
background image

uu

HomeLink® Universal Transceiver

*

u

Training HomeLink

326

Features

Training a Button

1

Training a Button

Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure.

Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.

If you have any problems, see the device’s
instructions, visit www.homelink.com, or call
HomeLink at (800) 355-3515.

1.

2.

Standard transmitter

Indicator remains on
for about 25 secs.

Rolling code transmitter

Indicator blinks rapidly for
two secs, then remains on
for about 23 secs.

Press and hold the desired HomeLink button
until the HomeLink indicator begins to blink.

Continue to hold the HomeLink button and
follow steps 1 - 3 under “Training a Button.”

1.

2.

YES

YES

YES

NO

NO

NO

HomeLink LED
is on.

HomeLink indicator blinks for 2 secs,
then remains on.

3.

Training

Complete

4.

5.

a.

a.

b.

Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the HomeLink
button you want to program.

Press and hold the desired HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink after 10 secs?

Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?

Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.
Does the LED blink within 20 secs?

The remote has a rolling code. Press the
“learn” button on the remote-controlled
device (e.g. garage door opener).

Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.

Press and hold the HomeLink button again.

Press and hold the
HomeLink button again.
The remote-controlled
device should operate.

Training Complete

15 US ODYSSEY-31TK86400.book 326 ページ 2014年7月1日 火曜日 午後2時4分

Advertising