HONDA 2008 Ridgeline - Owner's Manual - Manual (Page 187)

Put your fingers under the front
edge of the hood. The hood latch
handle is above the ‘‘H’’ logo. Pull
this handle until it releases the
hood, then lift the hood. Pull the support rod out of its clip,
and insert the end into either of
the designated holes pointed to by
an arrow.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
If the hood latch handle moves
stiffly, or you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated.
Park the vehicle, and set the
parking brake. Pull the hood
release handle under the lower left
corner of the dashboard. The
hood will pop up slightly. 1. 2. 3.
Service Station Procedures
Opening and Closing the Hood
B
e
fo
re
D
riv
ing
183
HOOD RELEASE HANDLE
LATCH
SUPPORT ROD
2008 Ridgeline
Table Of Contents Main Menu