HONDA 2007 Accord Sedan - Owner's Manual - Manual (Page 159)

4-cylinder models
4-cylinder models
V6 models
V6 models
To Close the Hood:
Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot
(30 cm) above the fender, then let it
drop. Make sure it is securely
latched.
Lower it to about a foot (30 cm)
above the fender, then press down
firmly with your hands. Make sure it
is securely latched.
Lift the hood up most of the way.
The hydraulic supports will lift it
up the rest of the way and hold it
up. Pull the support rod out of its clip
by holding the grip, and insert the
end into the designated hole in the
hood.
3.
158
SUPPORT ROD
V6 models 4-cylinder models
GRIP
Service Station Procedures
Main Menu Table of Contents s t Main Menu ▲ ▼ Table of Contents