HONDA 2007 Accord Sedan - Owner's Manual - Manual (Page 207)

Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your
dealer) is required. Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
Always change the oil and filter
according to the maintenance
messages shown on the information
display. The oil and filter collect
contaminants that can damage your
engine if they are not removed
regularly.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lift for this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Make sure the oil filter gasket is
not stuck to the engine block. If it
is, remove it before installing a
new oil filter.
3. 2.
1.
Changing the Oil and Filter
206
WASHER
4-cylinder models
WASHER
V6 models
OIL DRAIN BOLT OIL DRAIN BOLT
Main Menu Table of Contents s t Main Menu ▲ ▼