HONDA 2005 Accord Coupe - Owner's Manual - Manual (Page 121)

The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button. Adjust the volume by turning
the PWR/VOL knob.
Pushing the AUDIO DISPLAY
button will also turn on the system.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
XM Satellite Radio information is
available on page
.
You can use any of five methods to
find radio stations on the selected
band:
, , , the
preset bars/icons, and
.
The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it, or
touch the SCAN icon (models with
navigation system). You will see
SCAN in the display. The system will
scan for a station with a strong signal.
When it finds one, it will stop and
play that station for about 5 seconds.
Use the TUNE bar or
knob to tune the radio to a desired
frequency. Press the
side of the
bar or turn the knob right to tune to
a higher frequency, and press the
side or turn the knob left to
tune to a lower frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or side of the
bar, then release it.
If you do nothing, the system will
scan for the next strong station and
play it for 5 seconds. When it plays a
station you want to listen to, press
the SCAN button or touch the SCAN
icon again.
124
CONTINUED
On models with navigation system
To Select a Station
TUNE SEEK SCAN
AUTO
SELECT
SCAN
TUNE
SEEK
To Play the AM/FM Radio
Playing the AM/FM Radio
Fe
a
tu
re
s
119
Main Menu Table of Contents