HONDA 2005 Accord Coupe - Owner's Manual - Manual (Page 160)

As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
You should erase all three codes
before selling the vehicle.
To train an already programmed
HomeLink button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
following the steps under
.
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red
indicator begins to flash, then
release the buttons. If you have problems with training
the HomeLink Universal Transceiver,
or would like information on home
products that can be operated by
HomeLink, call (800) 355-3515. On
the Internet, go to
www.homelink.com.
HomeLink is a registered
trademark of Johnson Controls, Inc.
HomeLink Universal Transceiver
Erasing Codes Customer Assistance
Retraining a Button
‘‘Training
HomeLink’’
158
Main Menu Table of Contents