HONDA 2005 Pilot - Owner's Manual - Manual (Page 143)

Plug in the garage door opener
motor, then test the HomeLink
button by pushing it. Press and hold the remote control
button and one of the HomeLink
buttons at the same time. If you are training the second or
third buttons, go directly to step 1.
Unplug the garage door opener
motor from the house current.
Hold the end of the garage door
opener remote control 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink button you just trained.
If the red indicator blinks for 2
seconds, then stays on, you have a
rolling code garage door opener.
Go to ‘‘Training With a Rolling
Code System’’ (see page
).
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
The red indicator in HomeLink
should begin flashing. It will flash
slowly at first, then rapidly.
When the red indicator flashes
rapidly, release both buttons.
HomeLink should have learned
the code from the remote control.
3.
4.
5.
6.
7.
1.
2.
142
HomeLink Universal Transceiver
Fe
a
tu
re
s
141
The remote control you are training
f rom may stop transmitting af ter 2
seconds. This is not long enough f or
HomeLink to learn the code. Release
and press the button on the remote
control every 2 seconds until HomeLink
has learned the code.
Main Menu Table of Contents