HONDA 2005 Insight - Owner's Manual - Manual (Page 47)

This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
This indicator comes on if either
door or the hatch is not closed
tightly.
This indicator comes on as a
reminder that you must refuel soon.
This indicator normally comes on
when you turn the ignition switch to
ON (II) and goes off after the engine
starts. If it comes on at any other
time, there is a problem in the
electric power steering system. If
this happens, stop the vehicle in a
safe place, and turn off the engine.
Reset the system by restarting the
engine, and watch the EPS indicator.
If it does not go off, or comes back
on again while driving, take the
vehicle to your dealer to have it
checked. With the indicator on, the
EPS is turned off, making the vehicle
harder to steer. This indicator comes on with the
high beam headlights. For more
information, see page
.
This indicator comes on for a few
seconds when you turn the ignition
switch to ON (II). It will then go off
if you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine will not start (see
page
).
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page
).
This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
56
60 56
Canadian models only
Instrument Panel Indicators
High Beam Indicator Immobilizer System
Indicator
Door and Hatch Open
Indicator
Low Fuel Indicator
Electric Power Steering
(EPS) Indicator
‘‘Daytime Running
Lights’’ Indicator
46
Main Menu Table of Contents