HONDA 2003 Civic Hybrid - Owner's Manual - Manual (Page 207)

Start the engine and let it run until
the radiator cooling fan comes on
at least twice. Then stop the
engine.
Remove the radiator cap. Fill the
radiator with coolant up to the
base of the filler neck.
The cooling system capacity is:
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
Check the level in the radiator,
add coolant if needed.
Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
Install the radiator cap, and
tighten it to the first stop.
Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator up to the base of the
filler neck. This coolant is a
mixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required. 16.
17.
18.
19.
20.
21.
22.
23.
With 5-speed manual transmission:
With continuously variable transmission
(CVT):
Cooling System
Maintenance 204
FILLER NECK
Fill up to here
1.08 US gal (4.1 , 0.90 Imp gal)
1.06 US gal (4.0 , 0.88 Imp gal)
Main Menu Table of Contents