HONDA 2003 Civic Hybrid - Owner's Manual - Manual (Page 238)

If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
(Driver’s side)
Turn on the headlights to test the
new bulb.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Reinstall the upper part of the
windshield washer reservoir.
Install the holding clip on the stay
and lock it by pushing on the
center of clip.
3.
4.
5.
6.
7.
8.
1.
2.
CONTINUED
Replacing the Front Side Marker/
Turn Signal and Parking Light
Bulbs
Lights
Maintenance 235
BULB WEATHER SEAL
HOLD-DOWN WIRE CONNECTOR
Main Menu Table of Contents