HONDA 2000 Civic Hatchback - Owner's Manual - Manual (Page 182)

Lights
4. Remove the burned-out bulb by
pulling it straight out of the socket.
Push the new bulb straight into
the socket until it bottoms.
5. Reinstall the socket. Turn it
clockwise until it locks.
Test the lights to make sure the
new bulb is working.
6. Reinstall the brake light assembly.
Tighten the two screws securely.
On CX medel
Reinstall the caps on the brake
light assembly.
Replacing a Rear License Bulb
1. Remove the license light assembly
by carefully prying on the edge of
the lens with a flat-tip screwdriver
and pulling the assembly out.
2. Pull the lens from the bulb holder
by pulling the lens while squeezing
the tabs on both sides of the
holder.
3. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
CONTINUED
Maintenance
BULB
Main Menu Table of Contents