Interlogix TruVision Camera Mounts - Manual (Page 10)

8 TruVision Dome Brackets Installation Manual
3. Then screw the cup base onto the swan-neck
bracket and fasten with the locking screw.
4. Loosen the screws on the dome enclosure using
the supplied hex wrench and remove it.
5. Connect the cables to the dome camera.
Using two screws, attach the camera base plate
to the converter pan on the cup base.
6. Re-attach the camera enclosure to the camera.
Flush-mount installation (TVD-M2-FM)
Check the section “Overview: Fixed dome cameras by bracket” on page on page 16 to confirm that
the correct bracket is used with the camera.
Note: For safety purposes, the mounting surface must be able to support three times the combined
weight of the bracket, cup base, and camera.
5-inch dome indoor cameras
Use the TVD-M2-FM bracket. See “Bracket and cup base description” on page 2 for examples of
the assembled brackets.
To mount a flush-mount bracket on a ceiling:
1. On the false ceiling, mark the position and size of the housing pass-through hole. Cut a hole
with a diameter of between 176 and 180 mm. Make sure the cables for the camera are
prepared.
Note: The ceiling thickness must be less than 30 mm.