Interlogix KTD-405 Series User Manual - Manual (Page 29)

Chapter 3
Programming
25
Entering a new preset number or pressing will take you to the display shown in Figure 23.
10. At the command selection display, use the joystick (or the and keys) to scroll up and down
through the list of commands until you find the desired command. The commands are listed in
alphabetical order. Then press the key (
on the display) to save the selected command for the
reprogrammed soft key.
Note: Pressing the key returns you to the PRESS KEY TO PROGRAM display.
13. The KEY HAS BEEN PROGRAMMED display flashes briefly, then the PRESS KEY TO PROGRAM
display (Figure 24) returns. If you want to reprogram additional keys, repeat the process from step 4.
8. To change key assignments, press the + side
of the zoom, focus, or iris keys.
Figure 23. PROGRAM SOFT KEYS display
9. At the PRESS KEY TO PROGRAM display
(Figure 24), press any of the available
reprogrammable keys. You can also program
the shifted keys by holding the esc key and
pressing the key. (See
Reprogrammable keys
and commands on page 67.)
Figure 24. PRESS KEY TO PROGRAM display
11. At the PRESS KEY TO PROGRAM display
(Figure 24), press any of the available
reprogrammable keys. (See
Reprogrammable keys and commands on
page 67.)
Figure 25. Command selection display
12. At the CONFIRM COMMAND SELECTON
display, press the + side of the zoom, focus,
or iris key to confirm the assignment of the
command for the key or press to return to
the PRESS KEY TO PROGRAM display.
Figure 26. Confirm command selection display
PROGRAM SOFT KEYS?
_
PRESS KEY TO
PROGRAM:
SLW/STOP - Æ
STABILIZ
SLW/STOP -
Æ
STABILIZ?