Interlogix KTD-405 Series User Manual - Manual (Page 31)

Chapter 3
Programming
27
19. Pressing – or takes you to the OPERATING MODE menu. (See User programming on page 28.)
When you go into the User menu screens from the Supervisor menu, you can return to the Supervisor
menu by backing up with the key.
17. Pressing or entering a baud rate value
takes you to the SYSTEM CONTROLLER
display (Figure 29). A System Controller is
used with the HDS (High Density Switch)
system to provide more comprehensive
control of larger systems. In an HDS system,
the keypad asks the System Controller for
permission to access resources, including the
keypad itself. To allow the keypad to access
these resources, press the + key (YES).
Figure 29. SYSTEM CONTROL display
18. If either System Controller mode (Figure 29)
or local user code is active, the INACTIVE
TIMEOUT display (Figure 30) will appear
when navigating forward from the System
Controller display. The value you enter here
will determine the time in minutes that a
login will persist with no activity from the
user. If that time is exceeded, and there is no
activity, you will be logged off and will have
to log on again to continue operation. The
default value is zero, which means you will
never be logged off automatically.
Figure 30. INACTIVE TIMEOUT display
SYSTEM CONTROLLER?
(+)=YES (-)=NO
INACTIVE TIMEOUT
MIN 99