Cisco 7100 Series - Manual (Page 8)

6
Connect the Router to the Network
AC OK
DC OK
OTF
AC OK
DC OK
OTF
RX
TX E3 RX
5
TX E3 RX EN
CEL CAR ALM
I
CONS
FE 0 / 0 FE
ACT
0 / 1
AUX
0
2
7140 - 2AE3 100-240Vac 50/60Hz 5-2.5A 525W
RX EN
CEL CAR ALM
ACT
LNK
0 LNK 1
PWR
SYS
RDY
SLOT 0 SLOT 1
Ethernet hub
Cisco 7100 series router
Crossover
Ethernet cable
22068
8
10BaseT/100BaseTX ports
Fast Ethernet 0/0
(RJ-45)
7 6 5 4 3 2 1
Connect the Fast Ethernet
Ports
The 10BaseT/100BaseTX Fast Ethernet
ports support IEEE 802.3 and IEEE 802.3u
specifications for 10-Mbps and 100-Mbps
transmission over unshielded twisted-pair
(UTP) cables. These ports support
autosensing and autonegotiation of the
proper transmission mode with an attached
device.
Note: Unless noted otherwise, all
procedures apply to any Cisco 7100 series
router.
1 Attach a standard straight-through or
crossover Category 3 or Category 5
UTP cable directly to the RJ-45
receptacle on the router.
2 Attach the network end of the cable to
an Ethernet hub or end station.