Philips AZ 1011 - Manual (Page 10)

Radio
CD-Player
V\atìio reception
Playing a CD
1 Adjust the source selector to AM or FM
to select your desired waveband.
2 Turn TUNING to tune to a radio station.
To improve reception
- For FM, pull out the telescopic antenna
Incline and turn the antenna. Reduce Its length
if the signal is too strong (very close to a
transmitter).
- For AM the set is provided with a built-in
antenna so the telescopic antenna is not
needed. Direct the antenna by turning the
whole set
3 To switch off the radio, adjust the source
selector to TAPE/ off position and check
the cassette keys are released.
CD Player
Display indication for CD functions:
- - - : flashes when CD source just selected
- In stop mode: total track number
During CD playback: ► and current
track number
REPEAT/ REPEAT ALL when the
respective repeat mode is activated
- PROGRAM: when CD program active
- - - and PROGRAM: flashes when
program memory full
~ cr : no disc/ error in CD operation or
with the CD/ CD-(R) is blank or the disc
is not finalized (see Troubleshooting)
To open the CD door lift the CD door;at
the edge marked LIFT TO OPEN.
Insert a CD or CD-(R) with the printed
side facing up and press the CD door gently
close.
Press PLAY'PAUSE Ml on the set to
start playback.
To pause playback press PLAY'PAUSE
Ml.To resume, press PLAY*PAUSE Ml
again.
► flashes during pause
To stop CD play, press STOP ■.
To switch off the set, adjust the source
selector to TAPE/ off position and check
the cassette keys are released.
Note: CD play wilt also stop when:
- you open the CD compartment:
- you select AM, FM or TAPE sound
source:
- the CD has reached to the end.
10