Philips AZ 1011 - Manual (Page 12)

CD-Player Cassette Recorder
Programming track numbers
You may store up to 19 tracks in the
desired sequence. If you like, store any track
more than once.
1 In the STOP mode, press PROGRAM to
activate program mode.
-> 00 and PROGRAM flashes.
2 Press SEARCH or for your desired
track.
^ Your selected track number and
PROGRAM flashes,
3 Press PROGRAM to store the track.
00 and PROGRAM flashes, ready for your
next track selection,
4 Repeat steps 2 to 3 to select and store all
desired tracks in this way.
^ - and PROGRAM flashes in the display
if you attempt to program more than 19
tracks.
5 To play your program, press
PLAY*PAUSE HI
Reviewing your program
• In the stop position, press PROGRAM
repeatedly to see your stored track
numbers.
Erasing a program
You can erase the contents of the merriory
by:
- opening the CD door:
- selecting AM, FM or TAPE sound
source;
- pressing STOP ■ (twice during playback
or once in the stop position.)
Display: PROGRAM disappears.
CASSETTE RECORDER
Cassette playback
Adjust the source selector to TAPE/ off .
Press ST0P*0PEN HA to open the
cassette door and insert a recorded
cassette.
4 Press PLAY < to start playback.
5 To pause playback press PAUSE II.To
resume, press the key again.
6 By pressing SEARCH « or ►►, fast
winding of the tape is possible in both
directions,To stop fast winding, press
STOP'OPEN BA
7 To stop the tape, press STOP'OPEN BA.
• The keys are automatically released at the
end of the tape, and the set is switched off
except if PAUSE II has been activated.
12