Power supply system, Inserting the battery pack (sbc5217), Removing the battery pack (sbc5217) – Philips VKR 9010 User Manual
Page 12: Car battery cord (sbc5422), Power suppiy system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Power supply system
Inserting the battery pack (SBC5217)
^ Align the grooves of the left side of the battery
pack and the Camcorder.
2 Push the battery pack until it iocks v/ith a ciick.
Removing the battery pack (SBC5217)
^ Slide the battery eject lever to remove the
battery.
2 Pull out the battery pack.
AC adaptor (SBC5420)
Connect the DC input cable from the DC output
socket on the AC adaptor to the DC input socket
on the Camcorder.
2 Connect to the mains.
Note:
When a battery pack is attached on the AC adaptor,
the Camcorder cannot be supplied with power.
Car battery cord (SBC5422)
■| start the engine and insert the car battery cord
into the cigarette lighter socket.
2 Connect the other end to the DC input socket on
the Camcorder.
Notes:
• The car battery cord can only be used with 12V DC
negative-grounded vehicles.
• Do not start the car engine whiie the Camcorder is
powered by the car battery.
10