Canon Digital Video Camcorder ZR900 - Manual (Page 67)

65
CHECK THE INPUT
- The DV cable is not correctly connected to the DV terminal ( 49), or the connected digital device is turned
off.
- The video input signal is in a different television system (PAL or SECAM).
CONDENSATION HAS BEEN DETECTED
- Condensation has been detected in the camcorder ( 69).
CONDENSATION HAS BEEN DETECTED REMOVE THE CASSETTE
- Condensation has been detected in the camcorder ( 69). Remove the cassette.
COPYRIGHT PROTECTED DUBBING RESTRICTED
- You attempted to dub a copyright protected tape ( 52).
COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED
- You attempted to play back a copyright protected tape ( 52).
HEADS DIRTY, USE CLEANING CASSETTE
- Video heads are dirty. Clean the video heads ( 2).
INCORRECT TAPE SPECIFICATION PLAYBACK IS RESTRICTED
- You attempted to play back a tape recorded in a different television system (PAL or SECAM) or in a recording
standard not supported by this camcorder.
INPUT SIGNAL NOT SUPPORTED
- The digital device connected with the DV cable is incompatible with the camcorder.
REMOVE THE CASSETTE
- Camcorder stopped operating to protect the tape. Remove the cassette and reinsert it ( 27).
SET THE TIME ZONE, DATE AND TIME
- You have not set the time zone, date and time. This message appears each time you turn the power on until
you set the time zone, date and time ( 24).
TAPE END
- Tape reached the end. Rewind the tape or replace the cassette.
THE TAPE IS SET FOR ERASURE PREVENTION
- Cassette is protected. Replace the cassette or change the position of the protect switch ( 67).