Capresso Z5 - Manual (Page 6)

Example: Push and hold the 1-cup Coffee Button
until
ENOUGH? PRESS BUTTON When the
desired amount of coffee is in your cup, push the
1-cup Coffee Button again.
CONFIRMED
✔
Example: Push and hold the Cappuccino Button
until
ENOUGH MILK PRESS BUTTON . When
enough frothed milk is in your cup, press the
Cappuccino Button. Then the Z5/Z6 starts brewing
coffee.
ENOUGH? PRESS BUTTON . When
enough coffee is added press the Cappuccino
button again.
CONFIRMED
✔
.
Please note: To re-program temperature and
coffee strength see chapter T.
O) Installing and Activating the Clearyl
Cartridge. (watch DVD for details)
Rinse cartridge under running water.
Attach extension rod.
Remove water tank (empty), pull up cartridge holder
lid and install the cartridge to fit snugly inside the
fins. Close cartridge holder lid and fill tank with
water and replace.
You MUST ACTIVATE the filter NOW!
COFFEE READY . Push and hold the Rotary Dial
until you hear a beep. FILTER NO
Push the Rotary Dial and then turn until the Display
shows
FILTER YES . Push the Rotary Dial to con-
firm. INSERT FILTER PRESS BUTTON. Rinse
button illuminates. Filter is already inserted. Place
a 20 oz. container under the ACS system. Push
and hold the Rinse Button until the display shows
FILTER RINS . Do not interrupt. After 90 seconds
the display shows UNIT IS HEATING then
COFFEE READY . The water might show a slight
discoloration. This is normal.
Important: Do not let the filter dry-out. Filter needs
to be submersed in water (see page 20 Operating
Instructions).
P) Replacing the Clearyl Cartridge
After using 75 liters (2,500 oz.) of water the display
will remind you to change the filter:
COFFEE
READY / FILTER-CHANGE . You can still make
coffee but you should renew the filter within the
next few days.
Remove the old filter. Keep the extension rod!
Install new filter as explained above.
ACTIVATE as follows:
Place a 20 oz. container under the ACS system.
Push and hold the Rinse Button until the display