Cyclades AlterPath BladeManager - Manual (Page 164)

5: Advanced Configuration
5-2 Alterpath BladeManager Manual
Working from a CLI
The BladeManager allows you to use a command line interface (CLI) as an
alternative to the web interface. You may use Linux or Windows-based secure
shell (SSH) client. The same restrictions to the web management interface
apply to the CLI.
>> Logging In
1. To connect to the BladeManager, enter the following shell commands:
Note: The “l” in ssh-1 is the alphabet “l” as in lemon).
2. If you are an administrator, the system will display a menu.
You can either run the console shell from the menu
- OR -
Go directly to the system prompt.
See the sample print of a CLI session at the end of this chapter. If you are a
regular user, you will get the console shell alone, without a menu or system
prompt.
Shell Commands
A list of commonly used CLI commands for operating the BladeManager are
as follows:
> ssh -1 <username> <IP address of BladeManager>
> <password>
Command Use this command to:
man list list the available commands
man <command name> get a definition of a command
consolelist list all consoles allocated to you as defined in
the access control list.
console <console name> connect to the console.