Cyclades AlterPath BladeManager - Manual (Page 87)

First Time Configuration Wizard
AlterPath BladeManager Manual 4-5
• Enter Date (format MM/DD/YYYY)
• Enter Primary Ethernet IP Address (Static/None).
• Enter Secondary Ethernet IP Address (Static/None)
• Configure Ethernet Subinterfaces (Yes/No/List)
• Configure Ethernet VLANs (Yes/No/List)
• Enter Ethernet default gateway
• Enter System’s Hostname (30 characters max)
• Enter System’s Domain name (60 characters max)
• Enter Primary nameserver’s IP address
• Enter the NTP Server
• Enter email (SMTP) server
• Enter Authentication Method (local/radius/tacacs+/ldap/kerberos/nis/
active_directory)
Note: Depending on the Authentication Method that you select, the system
will prompt you for additional information. See “Setting the
Authentication Method” on page 4-8 for more information.
>> Resetting Configuration to Factory Settings
If you make a mistake during the First Time Configuration (or if you need to
make a change in the configuration), you can reset the configuration to its
factory default settings and start over. To reset the configuration, follow these
steps:
1. Log in to the management console as root.
2. Type in: defconf and press <Enter>.
3. Type in: reboot and press <Enter>.
Example:
BladeManager login: root
Password:
.
.
[root@BladeManager root]# defconf
WARNING: this will erase all of your current configuration and restore the
system's factory default configuration. This action is irreversible!