Cyclades AlterPath BladeManager - Manual (Page 43)

Installation Procedures
AlterPath BladeManager Manual 2-19
To install an adapter, complete the following procedure:
1. Review the safety installation guidelines at the beginning of this chapter.
2. Switch off the server and peripheral devices; disconnect the power cord
and all external cables.
3. Remove the cover.
4. Follow the cabling instructions that come with the adapter. Route the
adapter cables before you install the adapter.
5. Follow the instructions that come with the adapter to set jumpers or
switches, if any.
6. Loosen the captive screw on the rear of the server and remove the riser-
card assembly. Place the riser-card assembly on a flat, static-protective
surfaced.