Cub Cadet CSV 050 - Manual (Page 11)

Operation
5
11
Starting Engine
Pull out the choke knob located on the engine. See Fig. 5-1 1.
inset.
NOTE: Use of the choke may not be necessary if the engine
is warm or the air temperature is high.
Turn the engine switch to on. See Fig. 5-1 inset. 2.
Pull the starter grip lightly until resistance is felt, then pull 3.
rapidly to overcome compression, prevent kickback and
start the engine. See Fig. 5-1 . If engine does not start after
ten seconds of repeated pulls, wait a few minutes and
repeat.
NOTE: Do not allow the starter grip to snap back against
the rope guide. Return it gently to prevent damage to the
starter.
When the engine warms up, push in the choke knob.
4.
WARNING: Never run the engine indoors or in a
poorly ventilated area. Engine exhaust contains
carbon monoxide, an odorless and deadly gas.
Stopping Engine
Turn off the engine switch. 1.
Disconnect spark plug wire and ground against the engine 2.
to prevent unintended starting.
To Empty Bag
Unhook bag straps from the lower handle. 1.
Unsnap bag clip from the top of lower handle. See Fig. 5-2. 2.
Grasp bag handle with one hand and pull lock rod on 3.
mounting bracket with other hand toward engine to
release.
Lift bag off back of unit.
4.
Twist the two buttons on the back of the bag to unlock and 5.
empty contents. See Fig. 5-3. Hold bag handle and bag clip
while emptying the contents.
Compress bag opening and fold inner flap over opening.
6.
Fold outer flap over inner flap and insert buttons on the bag 7.
through metal outlets. See Fig. 5-3.
Figure 5-1
1
2
3
4
Figure 5-2
1
3
2