Cisco 10008 - Manual (Page 30)

30
Use the following procedure to connect a video terminal to the console port on a PRE:
Figure 23 Console Port Connection on the PRE
Step 1 Connect one end of the RJ-45 crossover cable to the serial RJ-45 port (CONSOLE) on the PRE.
Step 2 Run the cable up and through the cable-management bracket and connect the other end of the RJ-45 crossover cable
to the RJ-45 adapter (Figure 24). If your terminal is equipped with a DB-25 serial connector, use the RJ-45-to-DB-25
adapter. If your terminal is equipped with a DB-9 serial connector, use the RJ-45-to-DB-9 adapter.
Figure 24 Connecting an RJ-45-to-DB-9 Console Cable Adapter
Step 3 Connect the adapter to your video terminal to complete the cable connection.
Step 4 Power on your video terminal.
Step 5 Configure your video terminal to match the following default console port settings:
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
30027
C ONSO
LE
ETHERNET
LIN
K
AU
X
SLO
T 0
SLO
T 1
CISCO
10000
LINK
30028