Cleveland Range MKDL-125-CC - Manual (Page 12)

9
HEAT AUTO COOL
OFF
Manual Heating/
Cooling
1. Turn ACTIVE/BYPASS SWITCH
(25) to "BYPASS".
2. Turn CONTROLLER SWITCH
(25) to "HEAT" or "COOL".
3. For heat: open STEAM
VALVE (4) completely to boil,
or adjust to regulate
temperature.
For cooling: open STEAM
VALVE (4) completely.
BYPASS ACTIVE
Adding Water
Manually
1. Locate FAUCET SPOUT (13)
over desired kettle.
2. Turn on HOT or COLD WATER
VALVES (14 or 15).
Discharge Valve
1. For air valve: turn AIR
REGULATOR (2) clockwise to
open, or counterclockwise to
close.
2. For butterfly valve: push
handle in and pull upwards to
open.
2 1
OFF ON
OFF ON
2000
1930
ENT
PST OUT PGM
RST
Upper
Display
Lower
Display
Program
Indicator
Reset
Key Enter
Key Next
Key Down
Key
Turn POWER switch "ON".
Set required volume by first pushing the
key until the digit you want to change is
flashing in the lower display. Then use the
key to change the value of the selected digit.
When all digits are set, press the ENT key.
Note: The digital counter has been
preset at the factory and should
operate satisfactory. If installing a new
counter (or the configuration settings to
your existing digital counter become
corrupted) you must configure the
digital counter as shown in Service
Bulletin SE90036 prior to operation.
CONTINUE RESET
CONTINUE RESET
INTERRUPT
Locate delivery spout over
desired kettle.
Turn START switch to "RESET".
Delivery will start at "0" and stop at
preset volume.
To stop delivery at any time, turn
INTERRUPT switch to " ".
To complete delivery after
interrupting, turn START switch
to "CONTINUE"
Turn POWER switch to "OFF"
when meter is not in use.
3
4
5
6
7
DIGITAL WATER
METER OPERATING
INSTRUCTIONS