Philips PPC136C - Manual (Page 12)

□
C hannel I nstallation : Ai)DiN(i C hannels (M anually )
A uto Programming (see previ­
ous page) adds all the chan­
nels it can find (on your Antenna
or Cable TV system) into the TV's
memory. You may add other chan­
nels, or drop unwanted channels
from the list of channels in the
TV's memory.
iBEQIN)
With the Channel
Installation Menu onscreen
press the Menu button, or use
the Cursor (A) Up and Down
(▼) buttons, to select CHANNEL
with the TV’s highlight control
<!>'"
Press the Number, or CH(+,-),
buttons to select the channel you
^ want to SAVE (or DELETE).
<l>
Press the Menu, or Cursor
Down (T), button to select
CHANNEL RING with the high-
^ light control bar.
Press the Cursor Right (►) or
Left (-^ )button on the remote
to SAVE (or DELETE) the select­
ed channel number into memory.
Repeat steps 2-4 for each channel
you wish to add (or delete).
^^ress the STATUS/EXIT button
to remove the menu when you are
finished.
S m a k i H k i . i ’
Try it out. Press the
iCH(annel) +, - buttons.
The channels you SAVED should
appear. The channels you
DELETED should not appear.
If you need to SAVE (or
DELETE) a channel above 100,
use the CH (+, -) buttons. The
consumer remote control number
buttons can not select channels
above 99 (unless the 3 DIGIT
ENTRY Commercial mode Menu
control has been set to receive
such channel entries).
CHANNEL INSTALLATION
CHANNEL Iv 4
CHANNEL RING mrm:
INPUT ANTENNA
LABEL ( )
AUTO PROGRAM ►
EXIT ►
1
1 CHANNEL INSTALLATION 1
HHANNEI. TV 4
{CHANNEL RING saved !
INPUT
LABEL
AUTO PROGRAM
EXIT ANTENNA
( )
t
CHMNEL INSTALLATION
CHANNEL
CHANNEL ftltie
INPUT
LABEL
AUTO PROGRAM
EXIT
TV ■
FRO.
ANTENNA
)
SVIDEO I
Remember, you may add the FRONT (AA^);
AUX{iliary); and S-VIDEO inputs into the
TV’s channel scan program memory. Then, by
pressing the CH(annel) +, - buttons you may
quickly select the Audio/Video Input jacks on
the front and rear of the TV.
Select CHANNEL in the onscreen menu, then
press the CH (+, -) buttons to select either
FRONT (A/V)/ AUX(iliary)/ or S-VIDEO
inputs. Note: The AUX(iliary) Video modes
are located between the lowest and highest
channel numbers within the CHANNEL con­
trol.
12